Sunday, August 23, 2009

Strut Reconstruction

I just recently had a bit of a problem with the strut on the passenger side front of my Mustang. A pair of rather crucial bolts had gone missing, and in the process of losing them, my car became progressively worse and worse. It wasn't until recently that it was bad enough for me to stop and take time to really look into what was going on though. Here is what I found.

First, this is a picture of the strut tower on my driver side. In particular, note the two bolts right next to the strut tower:

Now - take a look at the passenger side...

You'll notice that both bolts are missing, and there is a pretty nasty tilt on the plate on the top of the strut tower. That's mostly bad, but that's not where the bad ended... The leftmost (in the picture above) bolt hole was totally stripped out, so there was no way I could get a new bolt in there...



The only thing left to do was drill and tap a new hole, which after a trip to Lowe's was quickly accomplished.


G">


The car now drives much better, and I feel much more comfortable driving it...

Nick

Sunday, June 21, 2009

Today I finished up work in the garage and built in a little workbench into the cubby in my garage. While it's not beautiful, I think it'll be pretty functional, and provides good storage room that I was in desperate need of.


Just want to give a short shout-out to my pop on this fathers day. He is the man I aspire to be, a father who has always deeply loved his family, and a shining beacon of the love and grace that Christ has shown to him. I can think of no greater compliment than when someone (often a family member who knows Pop well) tells me that I remind them more of my Dad than the last time they saw me.

Saturday, June 20, 2009

Another profitable Saturday...

Today I changed the oil in my car, build a couple saw horses, mowed the back lawn, and organized some more stuff.

The saw horses I built were based off this design, but I didn't want them to be quite that wide. Here are a couple pics of the results. Hope everyone is having a good weekend!



Wednesday, June 17, 2009

Life could not be better...

My first project was to install a ceiling fan in the master bedroom. I couldn't stand how quiet it was at night, and it was pretty warm in my room without any air circulating. Installing a ceiling fan isn't normally an all day affair, but it turned out to be one in this case. Not only am I a bit of a ceiling fan installation n00b, but there was not even a whole in the ceiling of my master bedroom for the fan...


As a result, it was up to the attic with me to punch a whole in my ceiling, install an electrical box, run some wiring, and while it was at it, do some minor rewiring of the wall outlets so that a single light switch didn't switch all three outlets in my room...

This was fairly straightforward (of couse, after bugging my Dad to death...) and turned into a junction box where I split the three wire circuit running from the switch into two two wire circuits - one that was switched (the ceiling fan) and one that was always hot (the outlets)


I then just had to cut the whole in the ceiling of my bedroom, run some wire through the electrical box, and hang the fan. Not a huge project, but I'm definitely sleeping better at night...

Here's a couple pictures of the house at the time that I bought it. I really liked the red brick all the way around the house, and the trees in the front and back. It was built in 1976, is 3 bed and 2 bath, and has quickly become very comfortable.




I have not yet laid in the hammock...
I just recently bought a new house in Austin. Most of the posts that follow will be regarding improvements / news about this house, although I may throw in a little bit of whatever else I wish...